Factory worksite lifting overhead light crane hoist system

Single Girder Gantry Cranes - Ram Hoist

b'2020-7-30\xe2\x80\x82\xc2\xb7\xe2\x80\x82Main girder and below support leg have two types: box-shape or truss-shape Box-shape crane: Single girder gantry crane with box is widely used with standard CD MD Electric Hoist as the lifting mechanism, and the electric hoist traversing along the lower flange of the I-Steel of the main girder, which is made up of high quality steel plates such ...'

SUBPART - Cranes and Derricks in Construction

b'The requirements in paragraphs (c) through (k) of this section apply to both floating cranes/derricks and land cranes/derricks on barges, pontoons, vessels or other means of flotation. (c) Work area control. (1) The requirements of \xc2\xa7 1926.1424 (Work area control) apply, except for \xc2\xa7 1926.1424 (a) (2) (ii).'

SUBPART - Cranes and Derricks in Construction

b'The requirements in paragraphs (c) through (k) of this section apply to both floating cranes/derricks and land cranes/derricks on barges, pontoons, vessels or other means of flotation. (c) Work area control. (1) The requirements of \xc2\xa7 1926.1424 (Work area control) apply, except for \xc2\xa7 1926.1424 (a) (2) (ii).'

Safety and OSHA Inspection Checklists - Grainger …

b'2 \xe5\xa4\xa9\xe5\x89\x8d\xe2\x80\x82\xc2\xb7\xe2\x80\x82Safety and OSHA Inspection Checklists. The most widely accepted means to identify workplace hazards is to conduct safety and health audits. One way to help understand a given situation is to look at it on a periodic basis. A survey conducted by the Occupational Safety and Health Administration (OSHA) in the late 1990s revealed that self-audits ...'

California Code of Regulations, Title 8, Section 1616.6 ...

b"(a) The use of equipment to hoist employees is prohibited except where the employer demonstrates that the erection, use, and dismantling of conventional means of reaching the work area, such as a personnel hoist, ladder, stairway, aerial lift, elevating work platform, or scaffold, would be more hazardous, or is not possible because of the project's structural design or conditions."

RAMS EXAMPLE 1 - ECEX

b'2021-2-25\xe2\x80\x82\xc2\xb7\xe2\x80\x82s. Crane operator to set up in car park t. AHU Manufacturer delivery vehicles to set up in car park u. Crane operator to commence lifting new unit onto the roof (see specialist RAMS attached) v. Fit new pads onto roof and position steels w. Drop sections of AHU onto the steels x. Repeat for all sections y. Bolt all new sections together z.'

Occupational Safety General Regulations - …

b'2017-12-10\xe2\x80\x82\xc2\xb7\xe2\x80\x82(p) \xe2\x80\x9choist\xe2\x80\x9d means a device or equipment and its structure used for lifting or lowering material, including cranes, an automotive lift, a winch, a chain fall or other similar device, but does not include a lift truck, a power operated elevating work platform, a device to which the Elevators and Lifts Act applies or a that operates in a ...'

Safe work with precast concrete | WorkSafe

b'2018-11-13\xe2\x80\x82\xc2\xb7\xe2\x80\x82Bracing anchors. Bracing anchors are used to connect the brace to the braced precast concrete element and the brace footing. They should be designed with a factor of safety of 2.5 against failure of concrete. If expansion anchors are used, capacity is \xe2\x80\xa6'